Facts on Living Water Vortexér

The jug contains 1,8 litre.


The process takes 3,3 to 7,3 minutes. The water is ready, when the bubbles have settled after about 10 minutes. The water quality reaches its highest after 4 hours, when the hydrogen molecules have stabilized after the process. The water holds the energy for a long time, sometimes months, but it is recommended to drink it within 1-2 days.

The propeller and the plug in the bottom of the jug is covered by 30 my pure silver, to prevent bacteria.

Rechargeable battery. About 50 jugs of water per charge. Use any 5V USB charger, 1A (5W) or more.

 

Practical use

3 programmed buttons control speed and time.

  • Always fill the jug exactly as marked to achieve an optimal vortex and thereby the best water quality.

  • The timer in the jug stoppes the propeller from spinning when the program is done.

  • The silver-coated propeller has an antiseptic effect. Remember to polish it if it becomes tarnished to maintain the antiseptic effect. Its delicate, so be gentle.

  • You may want to place the lid on a lukewarm radiator overnight approximately 1-2 times a week. This will remove any condensation, which might occur because of temperature shifts in the process. Place the lid with the propeller facing down.

  • Clean the jug before use.
  • Clean the jug and lid with a moistened cleaning tissue. Remove limestone stains with lemon or vinegar. Do not use any other types of solvents.

    Do not immerse the lid into liquid. Do not use dishwasher!

    ALWAYS REMOVE THE LID BEFORE PLACING THE JUG IN THE REFRIGERATOR.

 

Description of the function buttons:

Left symbol “few bubbles”: For plain tap water. Use this button when you have completed your 3 weeks of getting used to the energized water.

Middle symbol “many bubbles”: For slightly contaminated water, chlorinated purified water. Run the program twice, wait for the bubbles to disappear, before pressing the button the second time. The propeller runs for approx. 7-8 minutes. By using this program, the water will become stronger/more energized. In case of any discomfort go back to the symbol with fewer bubbles/left symbol.

Right symbol “tuning fork”: Programmed to get you started using the CLEAN WATER VORTEXér. See “Get started - daily use” for how to use this button. Few sensitive people go back and only use this program.

 

 

START UP AND DAILY USE

Many of our cell types are renewed within 21 days and it takes roughly this long to get used to the energetic quality of vortexed water, so we have calculated an acclimation period of approximately 6 weeks*.
During your start up phase use only the “tuning fork” button (for getting attuned).

Start up program:

Week 1:
Fill jug and push the “tuning fork” button once. Start with ½-1 glass of water on the first day. On day 2, if you do not feel any discomfort, drink 1-2 glasses. Continue this for a week.

Week 2 and 3:
A single push of the “tuning fork” button. Drink up to about 1 liter per 40 kilo body weight, as long as you do not feel any discomfort.

After 3-6 weeks without any discomfort, you are now ready to use a single push of the “few bubbles” setting. If you feel any discomfort – drink less.

When the body gets used to the altered energy and quality of the vortexed water, you may want to use the “many bubbles” program to increase the energy in the water. But if this seems too strong, go back to the previous setting.
Only run the “many bubbles” setting twice if you have very low quality water.

 


*VERY SENSITIVE?
Pay careful attention to the reactions of your body and slow down the process
further if needed. It is VERY IMPORTANT that you listen to your body – we all have different needs. If you have any sense of discomfort, go back to the previous program or drink smaller or fewer glasses a day. Remember, the water is completely safe – in conventional scientific terms, the vortexing process does nothing but add energy.

 

Read the user guide before using your new Living Water Vortexér